Painting Space Wolves the quick and easy way: Part 2

Introduction
Welcome once again to the joys of painting the Emperor's finest! Last time I got the Space Wolves painted in a a very simple way so that they could appear on the tabletop and defeat humanity's enemies with a nice, simple paint job. This time I'm going to do a bit more to improve the look without doing anything too difficult or time consuming.

First steps
The first thing to do was to tidy up some of the mistakes that I hadn't bothered with initially and to paint some of the bits that had skipped the first time round.

I tidied up the shoulder pads where my hand had slipped with the red or yellow using Codex Grey. I painted the purity seals using red and Bleached Bone. Since I had the colour on my palette, I went over the assorted wolf skulls and claws with bleached bone at the same time. Finally I used the same colour to drybrush the wolf pelts that two of the marines were wearing.

Shoulder Pads
There's no getting away from it; Space Marine shoulder pads are there to be decorated and space Wolves probably more than most since each one is an individual warrior.  There are basically three options when if comes doing shoulder pads; you can use transfers, one with a molded design or you can paint something free hand. As you can see below I managed to use all three options of the red shoulder pads!

On the left there's a paw print decal which seemed nice and characterful. Given that it's relatively small it was also quite east to apply. In the middle, there's a molded skull shoulder pad that I painted in the usual way and on the right is a simple geometric design that suggest a gaping maw - at least in my mind!

For the yellow shoulder pads I just applied the chapter symbol decals to each. The basic procedure is on the reverse of every sheet of transfers that GW produce.  A couple of things that make it easier to apply decals:

1. Paint gloss varnish on to the area first and to apply the decals quickly before it dries. The gloss varnish helps the decals to stick. You'll need to use some anti shine later to stop it looking glossy but that's a minor inconvenience. 
2. Use a pair of tweezers to pull the transfers out of the water. A paint brush can work too but I personally prefer tweezers.
3. Use some clean, dry kitchen paper to get rid of any excess water.

Decals are bit fiddly to do on curved surfaces like these, flat surfaces like shields are much easier, but I got them on in the end. The eagle eyed amongst you will notice that one tore slightly in the process but I decided just to leave it. This isn't a tutorial for perfectionists...

Painting the wolf skin

I quite liked the brown colour of the wolf skins, but I felt that the guy with powerfist needed something more traditionally wolfy in colour. (Powerfist =  veteran sergeant = curmudgeonly traditionalist space wolf in my mind. Go figure..) I painted over the brow with a light grey and then gave it a wash of watered down Codex Grey to put in some shading and picked out the eyes with yellow just to add a little colour. 

Basing the figures
I painted the bases with thinned Vallejo Khaki which is the nice light brown colour you can see. Since I'd glued the sand on the bases before I started painting and made sure they got sprayed with undercoat, this was a nice quick process! I then dabbed on some PVA glued and added the static grass.

I'm firmly of the opinion that even simple basing like this really improves a figure. Lots of Golden Demon entries put almost as much work into the base as they do into the figure.

All finished!

There you go, three Grey Hunters painted quickly and easily. There's numerous things that could still be done to them, the most obvious being highlighting

Return to the Painting Articles page.

Painting Space Wolves the quick and easy way: Part 1

Introduction
The goal of this tutorial is not to paint 'Eavy Metal standard or award winning minis, it is much simpler. How can you paint your Space Wolves quickly and easily so that they look nice on the battlefield?  Fortunately it's not particularly difficult or too time consuming.  I decided to paint my Space Wolves grey because I'm not that keen on the official colour scheme but with a few changes you could adapt this tutorial to the normal scheme.

Space Wolf Grey Hunter ready for battle!

Getting started
The first step of course is to clean and assemble your figures. It's worth investing a bit of time at this stage as flash and mould lines do look really ugly later on if you don't remove them. It's also a good idea to glue sand to the bases now because then you can spray undercoat it when you're doing the rest of the model. Gluing and painting the base later is more time consuming in the long run.

Space Wolves undercoated with Uniform Grey

The next step is undercoating. If you're a beginner you may like to check out the post I did on undercoating before you do this.  For quick and easy painting, a coloured primer from The Army Painter is a must. This gives you the undercoat and the base coat in one fell swoop which speeds things up by saving the bother of base coating.. I used Uniform Grey but they make Wolf Grey as well for those of you who like the studio colour scheme.

Shading the easy way with washes and inks
The next step is to put in some shading. I do this by liberally applying a wash to the models. I used Army Painter Strong Tone Ink On these models but any black ink or wash should do. If you don't have a commercially made one then thin down some black paint with water and use that, making sure it gets into the recesses. The figures should now look something like this, a bit grubby but very 3D with the shading! Most importantly you can see the detail clearly.

Black ink adds shading and brings out the details

Proper painting starts!
Now begins the fun part; adding colours. It helps immensely if you don't need too many different colours. These Space Wolves just have red, yellow, brown black and metal.Using a limited number of colours has several advantages. One, you don't need to have so many paints which is important for the beginner on a budget. Second, it as stops the figure looking gaudy; gaudy is virtually always a bad look.  The last is so obvious that I think it's easily overlooked. The fewer colours you use, the quicker the painting.

Another trick to painting quickly is to paint batches or groups of models together. Personally I find three or four is a good number. Whilst one is drying you can paint the next. Keep using the same colour until it's on all the models. Concentrate on being neat and getting a smooth coat. When you've finished go back and tidy up any mistakes.

Space Wolves painted the quick and easy way

So there we are: three Space Wolves ready to do battle for Russ and the Emperor! They won't win any painting awards but as a group they look just grand for the battlefield and they didn't take forever to do. There's plenty that could be done to improve them and in part 2 of this tutorial we'll do just that.

Final thoughts
There are many fantastic miniature painters out there on the Internet. Many who are far more talented then me in fact and have armies of beautifully painted figures that grace a 40K battlefield.  Hours of work have gone into the figures and each one is a miniature work of art. Pun intended. If you want a tutorial on that method there is a rather good one here on an awesome Space Wolf blog.

It can be inspiring to  admire these figures but it's also a bit disheartening if you don't have the time or the skill to paint to that standard - and most of us don't.  I think this is partly to blame for the numerous armies I've seen over the years which are unpainted or simply black undercoated figures. People think every figure needs to be 'pro painted' and are afraid to even start. Hopefully this tutorial will help you get started with painting your army.

If you want to improve the models you painted before to a nicer tabletop standard, check out part 2 of this tutoral on painting Space Wolves the easy way.

If you've found this post helpful, please take a moment to click the Google "+1" button at the bottom of  this page.  Whenever you give a page a "+1" you help Google to know that this a good page and ultimately help other people to find this information.

Thank you for the +1 validation and happy painting!

Return to the Painting Articles page.